www.geocities.jp/kkshrimp/guide/FLY_pro_ESC.pdf
Взято оттуда:
Option paremeter assistant by transmitter
The transmitter can set only one parameter of ESC at a time. If you want to set several parameters, please repeat the
following procedures:
Plug the JR connector into throttle control channel of receiver.
Switch “on” the transmitter and move the stick of throttle to the highest position.
Connect the main power pack to ESC (pay attention to the polarity).
Wait for 5 seconds, you will hear 4 beeps, that means it entered the programming mode.
And then you will hear 5 “single beep”, then 5 “double beep”, then 5 “triple beep”, then 5 “quartet beeps” and then 5
“penta groups”. And these sounds will circulate continuously.
Each group of 5 sounds stands for a different parameter of ESC respectively.
You can put the stick of throttle to the lowest position during one group of 5 sounds, then the corresponding mode is
saved.
Hear 1 “♪”(Brake-Medium) or "♪♪" (Brake-Off) , then you can exit the setting mode after saving the mode.
When the mode is saved, you can disconnect the ESC to the battery pack.
Brake: Hear the first “♪♪♪♪” in the above circulation, put the throttle stick to the lowest position, the braking mode is
changed from Brake-off into Brake-Medium. If you want to change back, please repeat the above procedures, and
vice versa.
Battery type: When you hear 5 groups “♪” or “♪♪” or “♪♪♪”, move the stick of throttle to the lowest position.
1 “beep”: Li-XX battery
2 “beep”: NiCd, NiMH battery
3 “beep”: LiFe battery
Timing: Hear 5 groups “♪♪♪♪”or “♪♪♪♪♪” , move the stick of throttle to the lowest position.
4 “beep”: Automatically change the timing of motor(recommended for all types of motors)
5 “beep”: Timing-High(recommended for 10 (or more) poles motors and outrunner motors)
Note: When the timing mode of motor is saved, please adjust the motor on the ground before the flight.